Type DID632

TROX DID632 series active chilled beams use a combination of primary air and chilled water (above the room dew point) to provide sensible cooling to the space. They combine the airflow characteristics of ceiling diffusers with the energy saving benefits of heat absorption using chilled water.The design and positioning of the induction nozzles within the DID632 active chilled beam enhances the amount of secondary room air drawn across the internal heat exchanger meaning that high cooling outputs can be achieved with low amounts of primary air.The beams discharge characteristics also allows for high levels of cooling without the penalty of very high terminal velocities (normally associated with high induction chilled beams) into the occupied zone and therefore makes the DID632 particularly suitable for perimeter zones with high sensible loads where comfort must be maintained.The high waterside to airside cooling ratio with low primary air volume means the DID632 is ideal for use with dedicated outdoor air system (DOAS) designs.
 
Benefits
 
  • Reduced ductwork
  • Reduced plant room sizes
  • Up to 130 Btu/h cooling per sq ft. of floor space, while still maintaining a maximum air velocity of 50 fpm in the occupied zone¹
  • 35% less primary air required for a typical application²
  • Can reduce main AHU air requirement by up to 82% compared to VAV systems
  • Up to 50% fewer chilled beams required for the same cooling capacity and primary airflow²

¹Based on room height of 10 ft and occupied zone height of 3.5 ft
 
²Compared to Trox DID622-HC active chilled beam
  • Product Description
  • Flush ceiling active chilled beam
  • Nominal width: 24" to suit t-bars at 2 ft centers
  • High cooling performance with low primary air flow air requirements
  • Two face designs
  • Two or four pipe configuration (heating and/or cooling)
  • Selection software featuring detailed comfort data and terminal velocities

References

Installation example DID632

Selection Tools

Selection Tool Selection Programm

Selection Tool

Selection Programm

more

Selection Tool BIM File

Selection Tool

BIM File

more

Share page

Recommend this page

Recommend this page by sending a link by mail.

Fields marked with an (*) are required fields.

Share page

Thank you for your recommendation!

Your recommendation has been sent and should arrive shortly.


Contact

We are here for you

Visual contact Visual contact

Please specify your message and type of request.
Tel.: +1-770-569-1433 | Fax: +1-770-569-1435

Fields marked with an (*) are required fields.

Contact

Thank you for your message!

Visual contact Visual contact

Your message is send and will be processed shortly.
Our department for Service-Requests will contact you asap.
For general question regarding products or services you can also call:
Tel.: +1-770-569-1433 | Fax: +1-770-569-1435

Contact

We are here for you

Visual contact Visual contact

Please specify your message and type of request.
Tel.: +1-770-569-1433 | Fax: +1-770-569-1435

Attachment (max. 10MB)

Fields marked with an (*) are required fields.

Contact

Thank you for your message!

Visual contact Visual contact

Your message is send and will be processed shortly.
Our department for Service-Requests will contact you asap.
For general question regarding products or services you can also call:
Tel.: +1-770-569-1433 | Fax: +1-770-569-1435