search-loading

Type DID600B


 

  • Flush ceiling mounting active chilled beam
  • Nominal width 600 mm
  • Top or side entry spigot for fresh air
  • Heat exchanger horizontal
  • Supply-extract-air combination available

The primary air volume flow required for fresh air supply enters the upper plenum box through a connecting spigot and is then discharged into the mixing zone via nozzles which are fitted into a diaphragm plate.

The induced air is drawn from the room through a water coil. In the mixing section of the DID600B the induced air is mixed with the primary air and the total discharged into the room via slots.

The DID600B can be used for cooling and/or heating. An additional spigot for extract of exhaust air can be fitted adjacent to the primary air duct (supply and extract air construction).

Reference

Tahoe Center for Environmental Sciences

TROX active chilled beams type DID602 installed in laboratories and classrooms
Reference

Contact

trox_usa_exterior_company_page_76

TROX USA, Inc.

4305 Settingdown Circle
Cumming
Georgia 30028
Tel: +1-770-569-14 33

Contact and locations