TROX DID632 series active chilled beams use a combination of primary air and chilled water (above the room dew point) to provide sensible cooling to the space. They combine the airflow characteristics of ceiling diffusers with the energy saving benefits of heat absorption using chilled water.The design and positioning of the induction nozzles within the DID632 active chilled beam enhances the amount of secondary room air drawn across the internal heat exchanger meaning that high cooling outputs can be achieved with low amounts of primary air.The beams discharge characteristics also allows for high levels of cooling without the penalty of very high terminal velocities (normally associated with high induction chilled beams) into the occupied zone and therefore makes the DID632 particularly suitable for perimeter zones with high sensible loads where comfort must be maintained.The high waterside to airside cooling ratio with low primary air volume means the DID632 is ideal for use with dedicated outdoor air system (DOAS) designs.

Benefits

• Reduced ductwork
• Reduced plant room sizes
• Up to 130 Btu/h cooling per sq ft. of floor space, while still maintaining a maximum air velocity of 50 fpm in the occupied zone¹
• 35% less primary air required for a typical application²
• Can reduce main AHU air requirement by up to 82% compared to VAV systems
• Up to 50% fewer chilled beams required for the same cooling capacity and primary airflow²

¹Based on room height of 10 ft and occupied zone height of 3.5 ft

²Compared to Trox DID622-HC active chilled beam

Manufactured in the USA